A loose toilet handle is more than just a nuisance. If the handle is loose then you may struggle to pull the flush. This results in a partial flush or in difficulty getting the toilet to flush at all. Naturally, this is frustrating and can cause people to wiggle the lever or even use excessive force to get the desired result.

In turn, this can cause the cistern or flush components to be broken, potentially causing a leak and a more expensive repair bill.

Top Tip: If in doubt when dealing with plumbing it is always best to get a reputable local plumber Sydney to come and fix the issue for you. Just like you browse through dramacool to watch the best show.

However, if you feel that this is something you can handle yourself then the following will be helpful:

Take A Look At The Problem

The first step is to inspect the handle mechanism. This means taking the top off the cistern and looking inside. It should simply lift off.

Place it aside carefully and inspect the inside of the handle mechanism. Move the handle gently outside the toilet and you may find that it is catching on something on the inside. Guide it past the obstacle and the handle may be fine again. It’s certainly worth a try.

Tighten The Handle

If there are no obvious obstacles the handle may simply have worked loose. To fix this you’ll need to start by shutting off the water supply to the cistern. You can now pull the handle to empty the cistern.

If this doesn’t work try lifting the central column inside your flush mechanism. This lifts the flapper and allows the water to drain from the cistern.

Now you’ll be able to look on the inside of your handle and you are likely to see a small nut, potentially one that needs an Allan key.

Tighten this nut and your handle will feel tighter, potentially solving the issue.

You’ll want to wiggle the handle and make sure it feels better before you turn the water supply on to check the handle is better.

Replacement

In rare cases, the toilet handle will be broken and need replacing. You can visit your local hardware store and pick up a new toilet handle. It’s a good idea to loosen the nut mentioned above, this will allow you to take the toilet handle with you and get the right replacement. You can also add this tip to your home improvement blog.

Fitting it is as simple as putting it in position and tightening the nut again.

Don’t forget to check the float level in your cistern and the effectiveness of the handle in lifting the flapper. Knowing these two parts are positioned and working correctly means you don’t have any other issues with your toilet that need to be looked at.

Remember, if you have any doubts regarding your toilet or plumbing then the professionals are here to help. All you have to do is give them a call and they’ll be on hand to fix everything.